Yamaha RX-V2600 Owner's Manual page 88

SYSTEM OPTIONS
■ Dynamic Range (Dynamic range)
Use to select the amount of dynamic range compression to
be applied to your speakers and headphones. This setting
is effective only when the unit is decoding Dolby Digital
and DTS signals.
To access these parameters, select:
Manual Setup > Sound > Dynamic Range >
Choices: MAX (maximum), STD (standard),
MIN (minimum)
Speaker
Headphone
Speaker (Speaker dynamic range)
Select to adjust the speaker compression.
Headphone (Headphone dynamic range)
Select to adjust the headphone compression.
• Select "MAX" to preserve the greatest amount of
dynamic range.
• Select "STD" for general use.
• Select "MIN" for listening to sources at low volume
levels.
■ Parametric EQ (Parametric equalizer)
Use this feature to adjust the parametric equalizer of each
speaker.
Manual Setup > Sound > Parametric EQ >
LFE Level
Dynamic Range
Parametric EQ
Tone Control
Audio Option
84
MAX
STD
MIN
Test Tone
Front L
Front R
1
Press k / n to select Test Tone or the speaker
you want to adjust.
• Test Tone turns on or off the test tone output
when adjusting the tonal quality of each speaker.
• Front L adjusts the tonal quality of the front left
speaker.
• Front R adjusts the tonal quality of the front right
speaker.
• Center adjusts the tonal quality of the center
speaker.
• Surround L adjusts the tonal quality of the
surround left speaker.
• Surround R adjusts the tonal quality of the
surround right speaker.
• Surround Back L adjusts the tonal quality of the
surround back left speaker.
• Surround Back R adjusts the tonal quality of the
surround back right speaker.
• Presence L adjusts the tonal quality of the
presence left speaker.
• Presence R adjusts the tonal quality of the
presence right speaker.
2
Press h to access the settings window.
Test Tone
Front L
Front R
Center
3
Press l / h to select PARAM and then press
ENTER to select a parameter from Band
(band), Freq. (frequency) or Q (Q factor).
4
Press n to select EDIT and press ENTER to
access the edit window.
Test Tone
Front L
Front R
Center
The parameter selected in PARAM is highlighted.
• Press l / h to adjust the parameter.
• Press k / n to adjust the Gain.
• Press ENTER to exit the edit window.
PARAM RESET
EDIT EXIT
Band / Gain
Band #1
Gain 0.0dB
Freq. 125.0Hz
Q 1.000