Using Clear - Yamaha RX-V2600 Owner's Manual

REMOTE CONTROL FEATURES
4
Press the buttons for the functions you want
to include in the macro operation in
sequence.
You can set up to 10 steps (10 functions). After you
have set 10 steps, FULL appears and the remote
control automatically exits the macro mode.
(U.S.A. model)
POWER POWER STANDBY POWER
TV AV
2
A XM AUDIO SEL SLEEP
3
PHONO TUNER CD MULTI CH IN
V - AUX
CBL/SAT MD/TAPE CD-R
DTV VCR 1 DVR/VCR2 DVD
Flashes alternately so you can
set the next step
Note
To change the selected source component, press
SELECT k / n
. Pressing the input selector buttons will
program a macro step, whereas
the selected component and corresponding component control
area.
5
Press MACRO again when the operation
sequence you want to program is complete.
Note
ERROR appears in the display window if you press a button
not indicated in the respective step, or if you press more than
one button simultaneously.
Memory back-up
The memory back-up circuit prevents the stored data
from being lost. However, the stored data will be lost
in case the power cord is disconnected from the AC
wall outlet for more than one week.
112
MCR 2: AV POWER
MCR 3: AUDIO SEL
MCR 1: DVD
1
Indicates the
number of macro
steps entered
SELECT k / n
only changes

Using CLEAR

You can clear all changes made in each function set, such
as learned functions, macros, renamed source names and
setup remote control codes.
■ Basic CLEAR operations
1
Set AMP/SOURCE/TV to AMP or SOURCE.
AMP
SOURCE
2
Press CLEAR by using a ballpoint pen or
similar object.
CLEAR appears in the display window.
CLEAR
Note
If you do not complete each of the following steps within 30
seconds, the clearing mode will be automatically canceled.
In this case, press CLEAR again.
3
Press k / n to select the clear mode.
L;CD Clears all learned functions in the respective
component control area. Press an input selector
button to select the component.
L;AMP Clears all learned functions for this unit's control
area.
L;ALL Clears all learned functions.
M;ALL Clears all programmed macros.
RNAME Clears all renamed source names.
FCTRY Clears all remote functions and returns the remote
to the factory settings.
Note
The name of a component is shown after a semicolon (;).
4
Press and hold CLEAR again for about 3
seconds.
WAIT appears in the display window. If clearing was
successful, C;OK appears in the display window.
CLEAR
y
Once you have cleared a learned function for a button, the
button reverts to the factory setting (or to the manufacturer
setting, if you have set remote control codes).
Note
L;ALL and FCTRY may take about 30 seconds to complete.
TV