Controlling Zone 2 And Zone 3; Zone 2 And Zone 3 - Yamaha RX-V2600 Owner's Manual

y
• You must complete this step within 5 seconds while the
selected zone flashes in the front panel display. Otherwise,
the currently selected zone mode is automatically
canceled. In this case, press ZONE CONTROL again.
• The initial setting is ZONE2 when both Zone 2 and Zone 3
are turned on.
3
Proceed to "Controlling Zone 2 and Zone 3"
on page 117 for detailed information on the
Zone 2 and Zone 3 control functions.
■ Remote control operations
1
Set AMP/SOURCE/TV on the remote control
to AMP.
AMP
SOURCE
TV
2
Press SELECT k repeatedly to select the
zone you want to control.
ZONE 2 or ZONE 3 is displayed in the display
window.
3
Proceed to "Controlling Zone 2 and Zone 3"
on page 117 for detailed information on the
Zone 2 and Zone 3 control functions.
4
Press SELECT k / n to exit from the
Zone 2/Zone 3 mode.
Notes
• The input source of Zone 2 and the source available for
recording are always the same.
• ZONE 2 or ZONE 3 appears in the display window only
when k is pressed, and ALL appears only when n is
pressed.
SELECT
or

Controlling Zone 2 and Zone 3

Once the zone you want to control is selected as described
in "Selecting Zone 2 or Zone 3" on page 116, you can
control Zone 2 and Zone 3 by using the control buttons on
the front panel or on the remote control. The available
operations are listed as follows:
• Selecting the input source of Zone 2 or Zone 3
• Adjusting the volume level of Zone 2 or Zone 3
• Adjusting the tonal quality of Zone 2 or Zone 3
• Tuning into FM or AM when TUNER is selected as the
input source of Zone 2 or Zone 3
• Tuning into the XM Satellite Radio when XM is
selected as the input source of Zone 2 or Zone 3
■ Selecting the input source of Zone 2 or
Zone 3
Use the INPUT selector on the front panel (or
press one of the input selector buttons on the
remote control) to select the input source of the
selected zone.
If the remote control is used to select the input source, "2:
name of the selected input source" or "3: name of the
selected input source" is displayed in the display window
when Zone 2 or Zone 3 is selected respectively.
INPUT
or
• Select TUNER as the input source to use the TUNER
features in the selected zone. For details about the
TUNER operations, see "FM/AM TUNING" on
page 47.
• Select XM as the input source to use the XM Satellite
Radio features in the selected zone. For details about
the XM Satellite Radio operations, see "XM®
SATELLITE RADIO TUNING" on page 53.
Note
The selected input source is shared across all zones.
y
You must complete this step within 5 seconds while the selected
zone flashes in the front panel display. Otherwise, the currently
selected zone mode is automatically canceled. In this case, press
ZONE CONTROL on the front panel again.
ZONE 2/ZONE 3
(U.S.A. model)
XM
A AUDIO SEL SLEEP
PHONO TUNER CD MULTI CH IN
V-AUX CBL/SAT MD/TAPE CD-R
DTV VCR 1 DVR/VCR2 DVD
117