Table of Contents
Advertisement
Removing the battery
The battery is secured to the radio by a battery catch in the radio's rear panel.
To remove the battery from the radio, so that the battery can be charged or replaced:
1. Rotate the power/volume control switch counterclockwise to turn off the radio.
If the battery has been removed while the radio is turned on, turn the radio off and then on again
before use.
2. Push the PRESS button at the bottom of the radio to release the battery catch, and pull the battery
away from the radio.
Attaching the antenna
Before using the radio, screw the antenna clockwise into the antenna connector. The antenna should be
screwed sufficiently tight so that it doesn't unscrew easily. This is important as it creates a seal.
Removing the antenna
Warning Do not change the antenna in a hazardous location. An explosion could cause
serious injury or death.
Use a firm grip and turn the antenna counterclockwise half a turn. Use a lighter grip to fully unscrew the
antenna, and carefully remove it.
Replacing the belt clip
1. To remove the belt clip, use a Pozidrive screwdriver to undo the two belt clip
screws.
2. To attach the belt clip, use a Pozidrive screwdriver to fasten the two belt clip
screws.
Tait International Ltd - March 2023
12
Advertisement
Table of Contents
