Honda CB350 Repair Manual page 137

132
CHASSIS
Boot clip
Boot
. Internal circlip
Piston
. Primary cup
Oil cup cap
Diaphragm
. Master cylinder
. Oil bolt
. Front brake hose
Front dise brake components
11.
12,
13.
14.
15.
16.
17.
18.
19.
20.
Bleeding the disc brake
Stop switch 21. Pod (outer)
3—way joint 22. Piston
Front brake hose 23. Caliper half (outer)
Front brake pipe 24. Bleeder valve
Caliper holder joint 25. Caliper securing bolts
Caliper holder 26. Front brake disc
Caliper adjust bolt 27. Caliper holder
Caliper half (inner) 28. Disc cover
Pad (inner)
Cotter pin
that the end of the tube is belowthe level
ofthe fluid in the container.
4. Apply the brake lever slowly sev—
eral times, then hold it ON.
5. While holding the brake lever on,
loosen the bleed screw. The brake lever
will be pulled toward the handgrip.
Close the bleed screw BEFORE the
lever bottoms out on the handgrip.
6. Repeat the procedure until the fluid
issuing from the lower end of the tube is
completely free ofair bubbles.
NOTE: During the operation, keep a
check on the reservoir fluid level,