Honda CB350 Repair Manual page 86

ENGINE AND TRANSMISSION
81
Removing the kick—startercirclip (350)
2. Check the condition of all circlips.
Replace any which are distorted.
3. Inspect the condition of the springs,
replacing any which are weak or broken.
4. 350 models: Check that the kick
gear rotates freely on the shaft gear. If the
6. 360 models: Check that the starter
gear binds, it should be repaired or re— ratchet moves freely on the shaft. If the
placed. ratchet binds, the ratchet and/orthe shaft
Kick—starter
shown
Kick—starter shaft
Kick—starter gear
Washer
Spring
Ratchet gear
Shim
Spring
components
10.
11.
12.
13.
5. 360 models: Inspect the condition should be replaced.
of the ratchet teeth on the kick gear and
thestarter ratchet. If the teeth are worn or Installation
damaged, replace the kick gear and the 1. Install the shaft into the lower
ratchet. crankcase half. Install the components on
$
13
(6
Kick—starter assembly ($1350)
1. Rubber 5. Return spring
2. Starter lever spring 6. Kick—starter shaft
3. Starter knuckle spring 7. Kick—starter gear
4. Circlip 8. Friction spring
9. Shaft stopper
10. Circlip
11. Idler gear
12. Driven gear
13.
(360):
Circlip
install
. Ratchet guide plate
. Shim
Return spring
Circlip
Shim
Circlip
in order