Shifter Mechanism - Honda CB350 Repair Manual

Oil pump O—rings (1) (360)
7. Install the oil pump andfilter screen
in the reverse order of removal, however,
note that the two O—rings behind the
pump must be in good condition. If in
doubt as to their condition, replace them
with newones.
SHIFTER MECHANISM
Removal and Installation
1. Remove the right crankcase cover
and clutch as described previously.
2. Remove the shift lever pinch—bolt
and pull the shift leveroff the shift shaft.
Removing the shift arm
3. Pull the shift arm down to disen—
gage it from the shift drum and pull the
shift shaft out of the right—side. On 360
models, remove the bolt from the drum
stopper and remove the stopper and
spring. On 350 models, remove the two
phillips head serews and their collars and
remove the drum stopper and the spring.
4. To install, refit the drum stopper
ENGINE AND TRANSMISSION
Shift drum stopper (360)
and install the mounting bolts. Do not
overtighten the bolts. Coat the shift shaft
with a light coat of grease and slip it
through the right—side of the engine. En—
sure that the fingers ofthe shift arm are in
contact with the pins in the shift drum.
5. Refit the clutch and the right crank—
case cover.
Inspection
1. Check that the collars on the drum
stopper bolts are not crushed. If this has
happened, replace them.
2. Check the splines on the gearshift
shaft. If the splines are broken or torn to
such an extent that it is difficult to prop—
erly secure the shift lever, replace the
shaft.
3. Check the shift arm. Be sure that it
is not bent. Check that the fingers of the
shift arm are not worn or bent.
4. Check the condition of the springs
in the shift linkage, especially the shift
Inspect the shift arm fingers