Panel Control; Octave; Note; Type Select & Sub - Yamaha PortaTone PSR-4000 Owner's Manual

NOTE

This switch turns reception of the note data on or off. When off, no notes will be produced by the
PSR-4000 even when note data is received on the selected channel.
CNTCNG Turns reception of control change data on or off. Control change data includes modulation wheel, foot
controller, and any other controller data (except the pitch bend wheel, which has its own switch, be-
low).
PRGCNG Turns reception of program change data on or off. Program change data corresponds to voice or
"patch" numbers, and will select the corresponding voices on the PSR-4000 when the PRGCNG pa-
rameter is on.
PITCHBND Turns reception of pitch bend wheel data on or off.
The parameters in this display page assign specific PSR-4000 panel controls to notes. The assigned notes
then control the corresponding panel control operations when received via a MIDI channel which is set to the
receive mode in the

OCTAVE

Use either the s and t LCD buttons to the left
of the display, or the
select the octave in which you want to assign a note.
The selected octave appears between the s and t
LCD buttons to the left of the display. The "C" note
in octave "3" corresponds to C3 (middle C) on the
keyboard.
NOTE
Use the LCD [ / ] control to select the
note to which you want to assign a panel control
function.
TYPE SELECT & SUB
Use the
assign a panel control function to the selected note.
The available panel control function types are listed
below along with the corresponding note-on (note
played) and note-off (note released) events for each
type. In some cases the
] controls are also used for type selection, as listed
below.

PANEL CONTROL

display, above.
LCD [ / ] control to
LCD [ / ] controls to
and LCD [ /
F8: MIDI
121