RODE Microphones NT1-A Quick Start Manual page 5

5. Fäst den andra monteringsgängan på din
studioarm, mikrofonstativ eller liknande fäste.
6. Anslut ena änden av den medföljande XLR-
kabeln till basen på NT1-A och den andra änden
till din interface, mixer eller liknande enhet.
7. Aktivera 48V fantommatning (P48) på din enhet
och börja spela in!
INDONESIAN
1. Untuk memasang filter pop ke shock mount,
sekrup ke dalam benang pemasangan dengan
bracket berbentuk 'L' hingga terpasang dengan
aman.
2. Letakkan NT1-A di dalam shock mount
dan putar mikrofon searah jarum jam untuk
mengencangkan dengan longgar ke dasar
mount.
3. Sesuaikan orientasi mikrofon sehingga titik emas
menghadap ke filter pop, kemudian kencangkan
cincin di bawah mount sambil memegang
mikrofon untuk mengamankannya di tempat.
4. Sesuaikan tinggi, kemiringan, dan putaran filter
pop sesuai selera.
5. Pasang benang pemasangan lainnya ke lengan
studio Anda, stand mikrofon, atau mount serupa.
6. Hubungkan satu ujung kabel XLR yang
disertakan ke dasar NT1-A dan ujung lainnya ke
interface, mixer, atau perangkat serupa Anda.
7. Aktifkan daya fantom 48V (P48) pada perangkat
Anda dan mulai merekam!
North America
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that
may cause undesired operation.
Please note that changes or modifications of this
product is not expressly approved by the party
responsible for compliance could void the user's
authority to operate the equipment.
NOTE: This equipment has been tested and
found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used
in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation.
If this equipment does cause harmful
interference to radio or television reception,
which can be determined by turning the