Errormessages - Elcometer 331 Operating Instructions Manual

elcometee ;
ERRoR
MESSAGES
13
ERROR MESSAGES
Under certain conditions the Covermeter will display error messages (Figure 21)
These messages
are
normally cleared by pressing any one of the softkeys
The cause of the error
will
be indicated
by
the message and should be
corrected before proceeding
Table 1:
Error messages
Error
message Causes
Action to
take
#1
-
PROBE
Search head{o-gauge
communication failure
Remove search head and refit
lf error oersists. return
to
Elcometer*
#2
-
PROBE
Corrupt data output from
probe
Try new search head
lf error oersists, return
to
Elcometer*
#3
-
PROBE lnternal
error
Return
to
Elcometer*
#4
-
PROBE
Search head power supply
fault
Remove
probe
lf
error persists, the
Covermeter
is
faulty
lf error clears, the
probe
is
faulty
Return
faulty
part to Elcometef
#5
-
PROBE
Internal
error.
Remove search head and reiit
lf
error
Dersists,
return
to
Elcometer*
PROBE
UNSUPPORTED
Old
Covermeter software does
not support new search head
Return
to Elcometer* for software
upgrade
PROBE CHANGED
Probe has been changed and
is not
comoatible with current
batch
Change to probe used when batch was
created
VALUE TOO
LARGE
Numerical
error
Switch Covermeter off then on again
lf error oersists contact Elcometer.
CLOCK lnternal
error.
Return
to Elcometer*
LANGUAGE
MEMORY
Software error
Return to
Elcometef
* Contact Elcometer
or
your Elcometer Supplier
to
arrange return
[2 -
FROEE
ERRBR-FREss
ff
HEV
BAR
ZERI]
Figwe
21. Example
error message
- search head
not connected
29