Table of Contents
Advertisement
DOWNROD-STYLE FAN MOUNTING
3. Slip downrod (C) into yoke, align holes and
re-install pin (D) and clip (E). Tighten downrod set
screws and then tighten nut.
Depending on the length of downrod you use, you
4.
may need to cut the lead wires back to simplify
the wiring. If you decide to cut back the lead
wires, it is suggested you do so in the following
manner:
Take the lead wires and make sure you have
pulled them all the way through the top of the
downrod. Start at the TOP of the hanging ball on
the downrod and measure 8 in. of lead wire, then
cut the excess wire off with wire cutters (not
included).
NOTE: If you do not cut back the lead wires,
Steps 4 and 5 are not necessary and you may
proceed to Step 6 instead.
5.
If you decided to cut back the lead wires in Step 4,
strip 1/2 in. of insulation from end of each wire --
WHITE, BLACK, GREEN and BLUE (if applicable).
Twist stripped ends of each strand of wire within
the insulation with pliers (not included).
3
F
E
H
4
5
9
C
D
Set Screw
and Nut
8 in.
Hanging
Ball
Advertisement
Table of Contents
