Table of Contents
Advertisement
TROUBLESHOOTING
WARNING: Before beginning work, shut off the power supply to avoid electrical shock.
PROBLEM
Fan does
1. Power is off or fuse is blown.
not move.
2. Faulty wire connection.
3. Reverse switch not engaged.
4. Plugs not connected properly.
1. Blades are loose.
Noisy operation.
2. Cracked blade.
3. Full range dimmer switch
4. Fan is new.
Excessive
1. Blades are loose.
wobbling.
2. Blade arms incorrectly attached.
3. Unbalanced blades.
4. Fan not securely mounted.
5. Fan too close to vaulted ceiling.
6. Set screw(s) on motor housing yoke is
7. Set screw on hanging ball is not
Fan operates but
1. Bulb(s) not installed correctly.
lights fail.
2. Wires in canopy not wired properly.
3. Wall switch to fan is off.
4. Wires in light kit fitter not wired
Remote control
1. Remote control transmitter not synced
fails to operate.
2. Battery not installed correctly.
3. Battery no longer working.
NOTE: A small amount of "wobble" is normal and should not be considered a defect.
POSSIBLE CAUSE
(are) not tightened properly.
tightened properly.
correctly.
with fan.
CORRECTIVE ACTION
1. Turn power on or check fuse.
2. Turn power off. Loosen canopy and
check all connections.
3. Push switch firmly either left or right.
4. Check that male and female plugs in
light kit fitter are connected properly
according to instructions on page 15.
1. Tighten all blade screws.
2. Replace blade.
3. Use only with included speed control
device.
4. Allow fan a "break in" period of a few
days, especially when running the fan
at Medium and High speeds.
1. Tighten all blade screws.
2. Re-install blade arms.
3. Switch one blade with a blade from
the opposite side.
4. Turn power off. Carefully loosen
canopy and verify that mounting
bracket is secure.
5. Use a longer downrod or move fan
to another location.
6. Tighten yoke set screw(s) securely.
7. Carefully loosen and lower canopy
and verify that set screw on hanging
ball is tightened securely.
1.
Re-install bulb(s).
1. Check wires in canopy and, if
necessary, re-wire according to
instructions on pages 12 and 13.
2. Make sure wall switch to fan is on.
3. Check that male/female plugs in light
kit fitter are connected properly
according to instructions on page 15.
1. Refer to instructions in Step 3 on
page 18.
2. Check that battery has been installed
with correct polarity.
3. Replace battery according to
instructions on page 17.
20
Advertisement
Table of Contents
