Table of Contents
Advertisement
FINAL INSTALLATION
1.
Temporarily lift canopy (F) to mounting bracket
(A) to determine which two canopy mounting
screws/lock washers (B) in mounting bracket (A)
align with slotted holes in canopy (F) and
partially loosen these two canopy mounting
screws/lock washers (B). Remove the other two
canopy mounting screws/lock washers (B). Now,
lift canopy (F) to mounting bracket (A) again,
aligning slotted holes in canopy (F) with
loosened canopy mounting screws/lock washers
(B) in mounting bracket (A). Twist canopy (F)
clockwise to lock. Re-insert the two canopy
mounting screws/lock washers (B) that were just
removed and tighten all canopy mounting
screws/lock washers (B) securely.
2.
DANGER: To reduce the risk of serious
bodily injury,
DO NOT use power tools to
assemble the blades (K). If screws are
overtightened, blades (K) may crack and break.
Partially insert three blade screws (AA) along
with three fiber blade washers (BB) into holes in
blade (K) to attach blade arm (M) to blade (K).
Then, tighten each blade screw (AA) starting
with the one in the middle.
Repeat for remaining blades (K) and blade arms
(M).
Hardware Used
AA
Blade Screw
BB
Fiber Blade Washer
1
Downrod
Option
F
2
AA
BB
x 15
x 15
14
Closemount
Option
B
F
H
K
M
B
H
Advertisement
Table of Contents
