Table of Contents
Advertisement
OPERATING INSTRUCTIONS
3. Restore electrical power.
IMPORTANT: To prevent damage to remote control
transmitter, remove the battery if not used for long
periods. Store the remote control transmitter away
from excess heat or humidity.
NOTE: If fan and/or remote control fail(s) to operate
or you have purchased a new remote control
transmitter, make sure to turn the power off first.
Restore electrical power. Within 30 seconds of
restoring electrical power, press and hold the
ON/OFF button (
transmitter for 5 seconds until fan beeps. Use the
remote control transmitter to test the light and fan
functions to confirm the learning process is
complete.
Operation buttons on the panel of the remote control
4.
transmitter:
3 button
2 button
1 button
0 button
button
Tap
button quickly to turn lights off or on. Hold
button down to increase or decrease lights. If you
press
button in excess of 0.7 seconds, it becomes
a dimmer. The lights vary cyclically in 8 seconds. The
light button has an auto resume function, which keeps
the light at the same brightness as the last time it was
turned off.
5. Use the fan reverse switch, located on the light kit
fitter (I), to optimize the fan for seasonal
performance. A ceiling fan will allow you to raise
your thermostat setting in summer and lower your
thermostat setting in winter without feeling a
difference in your comfort.
CAUTION: Turn fan off at wall switch and let
blades (K) come to a complete stop before
manually activating the reverse switch.
) on the remote control
for fan HIGH speed
for fan MEDIUM speed
for fan LOW speed
to turn fan OFF
to turn light ON or OFF
3
Remote Control Transmitter
4
Remote Control Transmitter
5
I
18
Reverse Switch
Advertisement
Table of Contents
