Table of Contents
Advertisement
WIRING
2.
Wrap electrical tape (not included) around each
individual wire connector (CC) down to the wire.
WARNING: Make sure no bare wire or wire
strands are visible after making connections.
Place GREEN and WHITE connections on
opposite side of the outlet box from the BLACK
and BLUE (if applicable) connections.
Hardware Used
CC
Wire Connector
3.
Gently slide remote control receiver (L) flat-side
up into mounting bracket (A). Turn spliced/taped
wires upward and gently push wires and wire
connectors into outlet box. Let antenna from
remote control receiver (L) hang to the side.
NOTE: The remote control included with this fan
meets the following requirements:
a. Not for use with solid state fans.
b. Electrical rating: 120V / 60 Hz;
x 3
motor amps:1.25 MAX.
2
CC
3
Antenna
13
CC
CC
A
L
Advertisement
Table of Contents
