Table of Contents
Advertisement
DOWNROD-STYLE FAN MOUNTING
6.
Install hanging ball of downrod (C) into opening of
mounting bracket (A). Align slot in hanging ball
with tab in mounting bracket (A).
DANGER: Failure to align slot in the ball with
the tab may result in serious injury or death.
Continue to WIRING on page 11.
CLOSEMOUNT-STYLE FAN MOUNTING
1.
Remove preassembled canopy cover from
bottom of canopy (F). NOTE: To remove
canopy cover, twist canopy cover until the two
small protrusions on the inner lip of the canopy
cover align with the two notches on the bottom
of the canopy (F). Pull on canopy cover to
remove.
NOTE: The downrod (C) and canopy cover
are not used in this type of installation.
2.
Locate the three raised, preassembled
screw/lock washers at top of motor housing
(H) and remove each one.
Pull wires up through hole in the middle of the
canopy (F) and attach canopy (F) to motor
housing (H) using the three previously
removed screws/lock washers.
6
C
1
2
10
Tab
Slot
Canopy
Cover
Screw/Lock Washer
A
F
F
Advertisement
Table of Contents
