Table of Contents
Advertisement
INITIAL INSTALLATION
5. Remove motor screws/lock washers (N) from
underside of motor housing (H) and save for
blade arm (M) attachment later on. [If there are
plastic motor blocks installed with the motor
screws/lock washers (N), discard the plastic
motor blocks.]
For DOWNROD-STYLE FAN MOUNTING,
proceed to step 1 below.
For CLOSEMOUNT-STYLE FAN MOUNTING,
skip to page 10.
DOWNROD-STYLE FAN MOUNTING
1a.
Remove pin (D) and clip (E) from downrod
(C).
1b.
Partially loosen preassembled set screws
and nut in yoke at top of motor housing (H).
2. Insert downrod (C) through canopy (F).
Then, thread wiring from motor housing (H)
through downrod (C).
5
1a
E
C
Yoke
H
2
F
8
N
Plastic
Motor
Block
1b
D
Set Screw
C
H
Advertisement
Table of Contents
