Table of Contents
Advertisement
. R PRESET: Selects one of 7 types of parameters
according to car type. (TYPE 1 ~ TYPE 7}
- BAND: Selects the band to be adjusted. (1 ~ 4: 1
and 2 are for low frequencies, 3 and 4 for medium
and high frequencies)
. FREQUENCY: Selects the centre frequency for the
adjustment. (1 and 2: 20Hz to 500Hz, 3 and 4:
630HZ to 20kKHz)
6. GAIN: Adjusts the level. (-12dB - +12dB8)
7. Q: Adjusts the sharpness of the frequency curve. (4,
3, 5, 7 and 20}
"Parameters 2 to 7 cannot be adjusted when the
"P.EQ F/R" parameter Is turned off.
<PINK NOISE>
Front + Rear -> All -> Off > Front
NOTES:
<Setting the DSP mode>
<Setting the equatizer mode>
22
7. TROUBLESHOOTING
Fuse is blown.
Replace with a fuse of the same amperage.
If the fuse blows again, consult your store of pur-
chase.
incorrect wiring.
Check the connections again and connect proper-
ly.
Playback head is dirty.
Use a cleaning tape, etc., to clean the head.
DOLBY NA button is not pres- | When listening to a tape recorded with Dolby NR,
sed.
press the DOLBY NR button and select B NR or C
NRA.
Power does not turn on.
{No sound is produced.)
Sound quality is poor.
Nothing happens when
buttons are pressed,
Turn off the power, then press the release button
and remove the front panel.
Microprocessor has malfunc-
tioned due to noise, etc.
Release button
Press the reset button for about 2 seconds with a
thin rod, etc.
DCP or Main Unit connectors | Wipe the dirt off with a soft cloth moistured in
are dirty.
alcohol.
DSP or equalizer does not
operate.
Microprocessor has malfunc- } Press direct button 1 (for more than 2 seconds)
tioned due to noise, etc.
while holding in the DSP
button, then turn the
power back on.
23
Advertisement
Table of Contents
