Swegon ESENSA Installation Instructions Manual page 6

Power supply cable connection - coil (Red)
RIGHT VERSION
picture 30 picture 31
V X
picture 32 picture 33
picture 34
Coil
picture 35
single-phase
10 www.swegon.com
MULTI.ESENSA.KW.230727
The coil cable runs up the holding tray and must pass through
the back of the electric cabinet.
The cable must pass through the membrane entry grommet
(component I1/I2 - picture 5 - page 4).
Use a cutter to remove the insulation (picture 30).
Use flexible wire grommet provided in the kit (kit n°2) : drill to
make a hole in the flexible wire grommet (picture 31) to suit
the cross-section of the cable.
Place the grommet and pass the cable (picture 34). Make sure
the grommet fits perfectly into the hole (pictures 32 & 33).
WIRING :
Strip the cable (after passing it through the
grommet).
We recommend crimping the wires using the
1.5 / 2.5 mm² insultated crimp ferrules supplied in
the kit (kit n°3 & 4).
The following diagrams show how to wire the coil
(preheating/postheating | single-phase/three-
phase) (pictures 35 & 36 ).
Coil
picture 36
three-phase
We reserve the right to alter specifications.
picture 32
picture 37 picture 38
CAUTION : terminals 13NO and 14 NO remain unused (picture 39).
X
X
picture 39
We reserve the right to alter specifications.
MULTI.ESENSA.KW.230727
Earth cable wiring : place the earth terminal strip
provided in the kit (kit n°7) and place it (picture 37) on
the slotted DIN rail (component E- Picture 5 - page 4).
Connect the earth wire of the power supply cable from the
coil to this new terminal block. See wiring diagram (pictures
35 & 36).
Contact wirings : connect the wires in the contactor. Use the
inlets T1 and T2 (and T3) (pictures 35 & 36). Use a screwdriver
to screw in/out (picture 38).
Always check that it is safetly installed.
Gather and tie the cables together using fasteners.
www.swegon.com 11