Table of Contents
Advertisement
Specification
42
Test/Restart Input
Muting A
Muting B
EDM - Monitor Input
Muting Lamp LMS
Input pulse characteristic
Safety Output (OSSDs)
Voltage Drop
Leakage current
Capacitive Load
Inductive Load
Test pulse data
Power Supply
Protection class (IEC 536 or
VDE 106)
Power-on delay
Insulation resistance
Dielectric Voltage Strength
Cable length
F3S-TGR-CL Transmitter
Cable length
F3S-TGR-CL Receiver
Cable length
F3S-TGR-CL-MIX system
Electrical
10 mA @ 24 VDC, Normally closed input, t
2,5s
10 mA @ 24 VDC
10 mA @ 24 VDC
10 mA @ 24 VDC
50 mA min @ 24 VDC (LED and bulb based lamps)
t
< 2xResponse time of the system
Pulse
Two PNP safety outputs, each output sourcing
250 mA @ 24 VDC. Short circuit protection
< 2.3 V
< 1 mA
< 250 nF for OSSD output
Please contact your Omron representative for further
information.
OSSD1
OSSD2
t
1
t
2
t1: Test pulse ≤300 µs
t2: Test interval = Response time x 0.33
t3: Repetition = Response time x 0.66
Must meet the requirements of EN/IEC60204-1 and
EN/IEC61496-1, and must guarantee safe insulation
from the mains voltage in accordance with IEC60742
and be able to cover a drop of supply voltage of at
least 20 ms.
III
<2 s
>20MΩ
350 VAC (1 min)
Connections
Shielded cables:
2
Max. 50 m, @ 0.4 mm
2
Max 100 m, @ 0.2 mm
Coding connections does not reduce the max cable
length
We recommend to use the F39-TGR-CVL cables
to connect the F3S-TGR-CL system to the
machine control system.
Shielded cables:
2
Max. 50 m, @ 0.4 mm
2
Max 100 m, @ 0.2 mm
Coding connections does not reduce the max cable
length
We recommend to use the F39-TGR-CVL cables
to connect the F3S-TGR-CL system to the
machine control system.
Shielded cables, M12 connector 8-pin, these cables
are shipped with the sensors. Maximum length is
0.9 m between segments
Section 14-1
>
Pulse
t
t
3
Advertisement
Table of Contents
