Advertisement
DRAFT 02
ABOUT THE POWER INSERTER
POWER INSERTER INSTALLATION
Keep in mind the following when installing the Wall Mount Power Inserter:
• Can be mounted in most standard electrical boxes.
• Requires a +12 Volt DC power source. (Inadequate voltage may cause the green LED to not illuminate and the unit to not
function properly.
• Requires .25" female spade connectors for power and ground connections.
• Has an internal fuse rated @ 400 mA max. If tripped, the fuse will reset when the circuit cools.
• Is not an amplifi er. No devices other than those shown below should be connected (unless approved by KING).
IMPORTANT!
When making connections, make sure
there is no power to the +12VDC and
ground lines, and the power inserter is
turned off (button not depressed).
More information https://www.caravansplus.com.au
Advertisement
