Road Traffic; Set Vehicle Detection - HIKVISION DS-2XS6A87G1-LS/4G User Manual

Sensitivity
Sensitivity stands for the percentage of the body part of an acceptable target that enters the
predefined region. Sensitivity = 100 - S1/ST × 100. S1 stands for the target body part that goes
across the predefined region. ST stands for the complete target body. The higher the value of
sensitivity is, the more easily the alarm can be triggered.
Threshold
The threshold for the time of the objects removed from the region. If you set the value as 10,
alarm is triggered after the object disappears from the region for 10s.
6. Optional: Repeat the above steps to set more regions.
7. For the arming schedule settings, see Set Arming Schedule . For the linkage method settings, see
Linkage Method Settings .
8. Click Save.
Note
The function is only supported by certain models. The actual display varies with the models.

10.4 Road Traffic

Vehicle Detection and Mixed-traffic Detection are available for the road traffic monitoring. The
device captures the passing motor vehicles and non-motor vehicles and uploads the relevant
information together with the captured pictures.
Note
For certain device models, you need to select Road Traffic on VCA Resource page first.
●
This function is only supported by certain device models.
●

10.4.1 Set Vehicle Detection

The vehicles that enter the set lane can be detected and the picture of the vehicle and its license
plate can be captured and stored. Alarms will be triggered and captures can be uploaded.
Before You Start
Go to VCA → VCA Resource , and select Road Traffic.
Steps
1. Go to VCA → Road Traffic → Detection Configuration , and select Vehicle Detection as detection
type.
2. Check Enable.
3. Select the total number of lanes.
4. Click and drag the lane line to set its position, or click and drag the line end to adjust the length
and angle of the line.
Network Camera User Manual
97