Table of Contents
Advertisement
ASSEMBLY
Assembly requires two persons. Place all parts of the exercise bike in a cleared area and remove the packing
materials. Do not dispose of the packing materials until assembly is completed.
In addition to the included tool(s), assembly requires a Phillips screwdriver
wrench
, and a rubber mallet
See the drawings below to identify the small parts needed for assembly. The number in parentheses below each
drawing is the key number of the part, from the PART LIST near the end of this manual. The number following
the key number is the quantity needed for assembly. Note: If a part is not in the hardware kit, check to see if
it has been preassembled. To avoid damaging parts, do not use power tools for assembly.
M8 Locknut
(72)–4
M8 x 20mm
Patch Screw (74)–4
1.
To make assembly easier, read the
information at the top of this page before
you begin.
Attach the Rear Stabilizer (3) to the Frame (1)
with two M10 x 95mm Patch Screws (76).
M8 Split
Washer (75)–8
M6 x 70mm Bolt Set (50)–1
M6 x 60mm Bolt Set (51)–1
.
M4 x 5mm
Bright Screw
M8 Washer
(43)–2
M10 x 95mm Patch
Screw (76)–4
1
3
76
5
, an adjustable
M4 x 16mm
Screw (90)–8
(91)–1
1
Advertisement
Table of Contents
