Table of Contents
Advertisement
User Manual for NC Freezers
CLEANING AND MAINTENANCE
WARNING - DAMP OBJECTS STICK TO COLD METAL SURFACES. DO NOT TOUCH THE INTERIOR METAL
After defrosting, wash the inside surfaces of the freezer with a solution of two tablespoons of baking soda in one
quarter of a gallon (1.1 liters) warm water. Rinse and dry. Wring excess water out of the sponge or cloth when
cleaning in the area of the controls, or any electrical parts.
Wash the removable parts and door basket with the baking soda solution, or mild detergent and warm water.
Rinse and dry. Never use metallic scouring pads, brushes, abrasive cleaners, or alkaline solutions on any
surface. Do not wash removable parts in a dishwasher. Do not spray water with a hose nor use ammonia based
cleaners.
WARNING - THE LOWER SIDE OF THE GLASS LIDS IS PROVIDED WITH A SPECIAL FILM. DO NOT USE RAZOR
BLADES OR OTHER SHARP INSTRUMENTS WHICH CAN SCRATCH THE SURFACE AND DAMAGE THE FILM
CLEANING THE OUTSIDE
•
Wash the cabinet with warm water and mild liquid
detergent. Rinse well and wipe dry with a clean soft
cloth. Do not spray water onto the unit with a hose,
or use ammonia based cleaners.
•
Once a week, clean each external and internal surface
with only a damp piece of cloth and neutral soap, and
dry them with a clean soft cloth.
•
Never use flammable or abrasive products. The unit
must never be cleaned with jets of water.
•
During maintenance and cleaning operations, make
sure there are good visibility conditions in the
working area, using as many light sources as needed.
Be very careful when working with moving and/or
high temperature parts.
Rev. 02/24
SURFACES WITH WET OR DAMP HANDS.
Beverage-Air
LID REMOVAL (IF REQUIRED)
•
Stand in front of the freezer
•
Assure that the lower lid is totally closed to the left
side of the freezer.
•
To remove the top lid, slide it open to it's maximum
handling it by both sides, and push it toward the back.
This allows the lid to get out from the front rail where
it slides, then remove it pulling the lid out from the
rear rail. Handle the lid carefully, and place it on a
flat, secure surface.
•
Repeat steps as needed.
•
To install the lids again, reverse the previous steps
starting with the lower lid.
Beverage-Air
11
Advertisement
Table of Contents
