Signals And Details Of I/O Terminal Block - Panasonic LP-RH Series Setup And Maintenance Manual

4-2 Signals and Details of I/O Terminal Block

The I/O terminal block is loaded with the basic input/output to control the laser marker.
„ List of signals
No. Name
X1 24V OUT
Internal power 24V
X2 IN COM. 1
Input common 1
X3 0V OUT
Internal power 0V
X4 REMOTE IN
X5 TRIGGER IN
X6 LASER SUPPLY IN
X7 TARGET DETECTION IN
X8 SHUTTER IN
X9 SHUTTER ENABLE IN
X10 LASER STOP IN
X11 LASER STOP IN
X12 OUT COM. 1
Output common 1
X13 ENCODER A IN
X14 ENCODER B IN
X15 ALARM RESET IN
X16 INTERLOCK 1(+)
X17 INTERLOCK 1(-)
X18 INTERLOCK 2(+)
X19 INTERLOCK 2(-)
X20 REMOTE INTERLOCK IN
• Use the internal power (X1, X3, Y1, Y3) as the power supply when operating the laser marker alone. Do not connect
anything when using the external power supply.
• Do not connect anything to RESERVE terminals.
• Some terminals are already connected by the jumper wires with shipment. Refer to "4-5-1 Factory default wiring" (P.112).
• For details on the terminal block connection, refer to "4-5 Connecting I/O Terminal Block" (P.112).
92
No. Name
Y1 0V OUT
Internal power 0V
Y2 OUT COM. 1
Output common 1
Y3 24V OUT
Internal power 24V
Y4 REMOTE OUT
Y5 READY OUT
Y6 LASER STANDBY OUT
Y7 SYSTEM STANDBY OUT
Y8 SHUTTER CLOSE 1 OUT
Y9 SHUTTER CLOSE 2 OUT
Y10 PROCESSING OUT
Y11 PROCESSING END OUT
Y12 PROCESSING FAIL OUT
Y13 MAINTENANCE OUT
Y14 WARNING OUT
Y15 ALARM OUT
Y16 INTERLOCK 1 MONITOR
Y17 INTERLOCK 1 MONITOR COM.
Y18 INTERLOCK 2 MONITOR
Y19 INTERLOCK 2 MONITOR COM.
Y20 LASER SUPPLY OUT
ME-LPRH-SM-3