Start-Up & Termination; Start-Up Procedure - Panasonic LP-RH Series Setup And Maintenance Manual

3-2 Start-up & Termination
WARNING

3-2-1 Start-up procedure

1.
Setup the laser marker connecting head and controller and interfaces.
Refer to "2-6 Connecting Laser Marker" (P.59).
2.
Turn ON the key switch of the controller.
The MAIN power indicator of the controller flashes.
3.
The system startup completes approximately after 10 seconds.
The MAIN power indicator of the controller changes from blinking light to steady light.
• Do not set the key switch to OFF until system startup has been completed.
• In case of turning ON the power supply after turning OFF, leave the interval five seconds or more between ON and OFF.
• In case the controller cannot startup with the ALARM indicator flashing (cannot connect online to Laser Marker NAVI
smart), contact our sales office or representatives.
4.
To configure and control by the PC configuration software, start Laser Marker NAVI smart and establish an online
connection with the laser marker.
• In Windows 11, open the start menu and select "All Apps" - "Panasonic-ID SUNX Laser" - "Laser Marker NAVI
smart".
• In Windows 10, open the start menu and select "Panasonic-ID SUNX Laser" - "Laser Marker NAVI smart".
Refer to "3-3-3 How to establish online connection" (P.76).
70
• It is obligated by IEC/FDA/JIS that laser products shall incorporate a key-
actuated master control. Actuation of this laser marker is basically controlled
by the key switch located on the front of the controller box. However, in
considering situations when the laser marker is operating as a part of a larger
system, the laser marker turns on if the key switch is already in ON position,
and power is supplied. In this case, be sure that the external system controls
the operation of the laser marker with a key-actuated master control.
OFF
ME-LPRH-SM-3
ON