Registered Characters/External Offset Marking - Panasonic LP-RH Series Setup And Maintenance Manual

4-6-16 Registered characters/external offset marking

ON
SELECT 0 - 2 IN
(No.19-21)
OFF
ON
D0 - D15 IN (No.3-18)
OFF
ON
SET IN (No.2)
OFF
ON
TRIGGER IN (X5)
OFF
ON
DATA WAIT OUT (No.38)
OFF
ON
SET OK OUT (No.28)
OFF
ON
READY OUT (Y5)
OFF
ON
PROCESSING OUT (Y10)
OFF
Item Time
T1 0.5ms or more
T2 0ms or more
T3 2 to 510ms
T4 ―
T5 2ms or more
T6 0ms or more
T7 ―
*1 : To specify the registered characters/external offset data number, set SELECT 0 IN to SELECT 2 IN as follows.
SELECT 0 IN (No.19): ON, SELECT 1 IN (No.20): OFF, SELECT 2 IN (No.21): OFF
*2 : Specify the data number of registered characters/external offset by using D0 IN to D15 IN. Refer to "4-3 Signals and
Details of I/O Connector" (P.101).
• SET IN (No.2) for the registered characters/external offset is acceptable when the laser pumping is completed, and the
internal shutter opens.
• If you have configured the registered characters/external offset function, READY OUT (Y5) will not be output until the
data number and SET IN (No.2) are input.
• Enter the data number input and SET IN (No.2) every time for each marking trigger even there is no change to the
marking data.
• Close the shutter if you want to reset the data number after turning on SET IN (No.2).
• READY OUT (Y5) will be output even when specified the data number without any settings.
*1
*2
Data A
T1
T6 T2
T3
T4
Data A
Remarks
After a lapse of 0.5ms or more from specifying SELECT 0 IN to SELECT 2 IN and D0 IN to
D15 IN, turn on SET IN (No.2).
Keep the input until SET OK OUT (No.28) turns on.
One-shot output. Set the output time on the system settings screen. There is a small
margin of error for the setting value.
Time for data creation. It varies depending on the quantity of the setting data.
Keep the ON status for 2ms or more.
Input SET IN (No.2) after DATA WAIT OUT (No.38) turns ON.
• When the next marking data compiling has finished within the trigger processing time:
1ms or less
• When the next marking data compiling did not finish within the trigger processing time:
The remaining time of the marking data compiling (T4)
ME-LPRH-SM-3
Data B
T1 T1
T6 T2 T6
T5
T3
T4
Data C
T2
T5 T5
T3
Data B
Data C
T7
133