Yaesu FT-1802M Operating Manual page 72

"S " M
ET
R S
Activates/Deactivates the Automatic Repeater Shift
feature.
Sets the Repeater Shift direction.
Sets the magnitude of the Repeater Shift.
CTCSS/DCS/EPCS S
Selects the CTCSS/DCS/EPCS Bell Ringer repeti-
tions.
Setting of the DCS code.
Enables/Disables "Inverted" DCS code decoding.
Enables/Disables the Enhanced CTCSS Paging &
Code Squelch function.
Enables/Disables the Answer Back function of the
Enhanced CTCSS Paging & Code Squelch function.
Setting the Receiver Pager Code for the Enhanced
CTCSS Paging & Code Squelch function.
Setting the Transmitting Pager Code for the Enhanced
CTCSS Paging & Code Squelch function.
Enables/Disables the split CTCSS/DCS coding.
Selects the Tone Encoder and/or Decoder mode.
Setting of the CTCSS Tone Frequency.
Enables/Disables the receiver audio output during the
Tone Search Scanner is activated.
Selects the Tone Search Scanner speed.
ARTS™ S
Selects the Beep option during ARTS™ operation.
Selects the Polling Interval during ARTS™ operation.
Enables/Disables the CW identifier during ARTS™
Operation.
M S
Select the Memory Bank for the Memory Bank Link
Scan.
Programming an Alpha/Numeric label for a Memory
Bank.
Selects the method of selection of channels for
Memory Storage.
Programming an Alpha/Numeric label for a Memory
Channel.
Enables/Disable the Band-edge beeper while scan-
ning.
Selects the Memory Scan mode.
SCAN S
Selects the Scan Resume mode.
Selects the Memory Scan mode.
Select the VFO Scanner Width.
DTMF S
Enables/Disables the DTMF Autodialer feature.
Setting of the DTMF Autodialer's TX Delay Time.
Loading of the DTMF Autodialer Memories.
Setting of the DTMF Autodialer Sending Speed.
70
M
ENU ODE
S M I A
4 ARS ON / OFF
43 RPT –RPT / +RPT / SIMP
0.00-99.95 ( MHz ) ( 0.60MHz )
46 SHIFT
S M I A
7 BELL 1 / 3 / 5 / 8 / CNTNUE / OFF
14 DCS CD 104 standard DCS codes
( 023 )
15 DCS RV ENABLE / DISABL
32PAGER ON / OFF
33 PAG.ABK ON / OFF
--- ( 05 _ 47 )
34 PAG.CDR
--- ( 05 _ 47 )
35 PAG.CDT
48 SPLIT ON / OFF
49 SQ TYP TONE / TSQL / DCS / RV TN /
OFF
52 TN FRQ 50 standard CTCSS tones
( 100 Hz )
54 TS MUT ON / OFF
55 TS SPD FAST / SLOW
S M I A
2 AR BEP IN RNG / ALWAYS / OFF
3 AR INT 25SEC / 15SEC
11 CW ID ON / OFF
S M I A
8 BNK.LNK ---
9 BNK NM ---
29 MW MD NEXT / LOWER
30 NM SET ---
21 EDG.BEP ON / OFF
28 MEM.SCN TAG1 / TAG2 / ALL CH
S M I A
41 RESUME BUSY / HOLD / 3SEC / 5SEC /
10SEC
47 SKIP SKIP /ONLY / OFF
56 VFO.SCN ±1MHz / ±2MHz / ±5MHz / ALL
S M I A
17 DT A/M MANUAL / AUTO
18 DT DLY 50 / 250 / 450 / 750 / 1000 (ms)
19 DT SET ---
20 DT SPD 50 / 100 (ms)
FT-1802M O
V
V
V
V
V
V
M