Cloning - Yaesu FT-1802M Operating Manual

The FT-1802M includes a convenient "Clone" feature, which allows the memory and con-
figuration data from one transceiver to be transferred to another FT-1802M. This can be
particularly useful when configuring a number of transceivers for a public service operation.
Here is the procedure for Cloning one radio's data to another:
1. Turn both radios off.
2. Connect the user-constructed cloning cable between the MIC jacks of the two radios.
3. Press and hold in the [ LOW ( A/N )] key while turning the radios on. Do this for both
radios (the order of switch-on does not matter). "CLONE" will appear on the displays of
both radios when the Clone mode is successfully activated
in this step.
4. On the Destination radio, press the [ D/MR ( MW )] key
("--WAIT--" will appear on the LCD).
5. Press the [ MHz ( SET )] key on the Source radio; "- - - -TX- - - -" will appear on the Source
radio, and the data from this radio will be transferred to the
other radio.
6. If there is a problem during the cloning process, "ERROR"
will be displayed. Check your cable connections and bat-
tery voltage, and try again.
7. If the data transfer is successful, "CLONE" will appear on both displays.
8. Press any key to exit to normal operation.
9. Turn both radios off and disconnect the cloning cable.
Pin 4: GND
Pin 6: PTT/CLONE
FT-1802M O
Pin 6: PTT/CLONE
Pin 4: GND
M
C
LONING
67