Yaesu FT-1802M Operating Manual page 35

8. If you wish to store another DTMF string, repeat steps 2 through 6 above.
9. Press and hold in the [ MHz ( SET )] key for one second to save the new setting and exit to
normal operation.
To transmit the memorized telephone number, use the following procedure:
1. Press and hold in the [ MHz ( SET )] key for one second, then
rotate the DIAL knob to select "17 DT A/M."
2. Press the [ MHz ( SET )] key, then rotate the DIAL knob to
set this Set Mode Item to "AUTO."
3. Press and hold in the [ MHz ( SET )] key for one second to save the new setting and exit
to normal operation.
4. In the Autodialer mode, which you just engaged, first press the PTT switch, then press
the microphone's numeric key ( [ 0 ] through [ 9 ] ) corresponding to the DTMF memory
string you wish to send. Once the string begins, you may release the PTT switch, as the
transmitter will be held "on the air" until the DTMF string is completed.
While the DTMF Autodialer is activated, the " " icon will
appear on the LCD.
To disable the Autodialer function mode, select "MANUAL" in step 2 above.
The speed at which the DTMF digits are sent can be changed. Two speed levels are avail-
able: Low (10 digits per second) and High (20 digits per second: default). To toggle between
Low and High speed, use the following procedure:
1. Press and hold in the [ MHz ( SET )] key for one second, then
rotate the DIAL knob to select "20 DT SPD."
2. Press the [ MHz ( SET )] key, then rotate the DIAL knob to
select the desired speed ("50": High speed or "100": Low
speed).
3. Press and hold in the [ MHz ( SET )] key for one second to save the new setting and exit to
normal operation.
You can also set a longer delay between the time your transmitter is keyed and the first
DTMF digit is sent. To set the delay time, use the following procedure:
1. Press and hold in the [ MHz ( SET )] key for one second, then
rotate the DIAL knob to select "18 DT DLY."
2. Press the [ MHz ( SET )] key, then rotate the DIAL knob to
select the desired speed (50 250 450 750 1000 ms).
3. Press and hold in the [ MHz ( SET )] key for one second to save the new setting and exit to
normal operation.
FT-1802M O
DTMF O
DTMF A
UTODIALER
M
PERATION
33