Table of Contents
Advertisement
• No header extensions (X=0)
• No CSRC list (CC=0)
• Payload type set to MPEG-2 Transport Streams (PT=33)
For more details, please consult RFC 1889, section 5.1. The 9990-TRX-MPEG does not receive,
require, or process RTCP packets.
Established Connections
This section lists output connections currently established to the selected IP input. An example
of the list is displayed below:
Individual connections can be removed the checking the corresponding box in the Remove
column.
The Apply/Cancel Buttons
Once the configuration information is filled in, click on the Apply button to make it active. If
there are no errors, the port will be created, and the configuration area disappears. If any errors
are detected, they will be displayed at the top of the Apply button. The following errors are
flagged:
•
Error: enter a Source Address or select "Any
for Source but left the Source Address field as 0.0.0.0.
•
Error: X.X.X.X is NOT a multicast
entered an address that is not multicast. Multicast addresses go from 224.0.0.0 to
239.255.255.255.
•
Error: X.X.X.X is NOT a valid unicast
Valid unicast addresses go from 0.0.0.1 to 223.255.255.255, with the exception of the
loopback range of 127.0.0.0 to 127.255.255.255.
•
Error: Primary and Backup settings are the
configuration settings for the primary and backup address/port. They must have at least
one difference.
•
Error: Primary/Backup UDP Port/Address conflict with Port X/Y
are attempting to configure an address/port combination that is already in use by another
input in the same Ethernet port. The 9990-TRX-MPEG is capable of internally
replicating transport streams; just use the other port again in the connection. There is,
Address": you selected Specific Address
address: you selected multicast reception, and
address: you entered an invalid unicast address.
same: you entered the exact same
37
Primary/Backup: you
Advertisement
Table of Contents
