Table of Contents
Advertisement
Automatic: In this mode, the ASI output bit rate is automatically set by
the 9990-TRX-MPEG to match the programs routed to the port.
o Bit Rate: This field is only shown if the ASI Rate control is set to Manual.
Enter the desired bit rate in bits/second.
o Transport Stream ID: Enter the desired Transport Stream ID for the port.
This value comes out in the Program Allocation Table (PAT).
o Pass PMT Changes: This checkbox controls whether PMT descriptor
changes from the connected programs are propagated to the output PMT for
this port. This box defaults to checked, and in most cases it should be left
checked. Only uncheck it if you want to isolate the devices downstream of
the transcoder from table changes.
o Generate SDT: If you check this box, a Service Description Table (SDT) will
be generated. Service Names will come from the connected programs. If this
box is checked, another field is displayed:
o Original Network ID: Enter the desired Original Network ID. For
applications where Network IDs have not been assigned, leave this field at
0xFF01.
• The Established Connections table. This indicates all the current connections from the
port. Connections can be removed by clicking on the corresponding box in the Remove
column.
• The Add Connection area. This allows for a new connection to be added to this port.
This control is available for all ports, and is described in detail in the Connections
section.
29
Advertisement
Table of Contents
