Disassembly And Assembly; Lid Removal; Figure 2.1-1: Remove The Four Screws On The Top; Figure 2.1-2: Remove The Six Screws On The Sides - HHB CDR-882 DualBurn Service Manual

2 Disassembly and assembly

In general the assembly is the reverse process of disassembly. Thus, only disassembly
is explained in this section.

2.1 Lid removal

For a majority of service operations it will be necessary to remove the lid.
1. First remove all the screws that hold the lid to the chassis. There are four screws
on the top (labelled as "A" in Figure 2.1-1), three screws on each side (labelled as
"B" and C" in Figure 2.1-2) and seven screws on the rear (labelled as "D" in
Figure 2.1-3).
2. Slide the lid horizontally away from the front panel to unlock the lid (as in Figure
2.1-4). Lift vertically away from the chassis to remove it completely.
CDR-882 Service Manual

Figure 2.1-1: Remove the four screws on the top

Figure 2.1-2: Remove the six screws on the sides

Figure 2.1-3: Remove the seven screws on the rear

Figure 2.1-4: Push to unlock lid

Version 1.3 Page 6 of 37