Firmware Updates; Cdr-882 Firmware Update - HHB CDR-882 DualBurn Service Manual

5 Firmware updates

Performing a firmware update restores all menu settings to their original factory
defaults. Firmware updates are downloadable from the HHB website. It may be
worthwhile checking through the menus and noting the current settings so that they
can be easily restored after the update. Updating the firmware requires a PC or Mac
fitted with a CD- (or DVD-) writer drive, and a CD-writing software application. We
recommend you read through the instructions below before performing an update for
the first time.

5.1 CDR-882 firmware update

To perform a firmware update, proceed as follows:
1. Download the new firmware from www.hhb.co.uk. It will be in the form of a
.wav file.
2. Save it to a suitable location
3. Using the CD burning application you have on your computer (such as Nero or
Roxio), create a CD containing the .wav file. The CD must be an audio CD, not a
data CD, and the .wav file must be the only track on the CD
4. Turn on the CDR-882, put the burnt disc into Drive 1 and close the tray. Note that
the update CD must be the first CD loaded after power is applied to the unit; if
there is already a disc in Drive 1, remove it first and reboot the CDR-882 (turn it
off and then back on) before loading the update CD
5. After the disc has been read, a dialogue screen will be displayed asking for
confirmation to update the firmware.
6. Press RECORD to continue or STOP to abort
7. The firmware update will now proceed automatically. The progress of the update
procedure is displayed by the L bargraph meter. Also, the display will show a
succession of messages:
!!! Updating OS !!!
Do not disturb power
Erasing flash completed
Writing flash completed
!!! Reboot !!!
8. During the update procedure, it is essential that the power supply to the CDR-882
is not interrupted. Should this occur, the unit may be rendered unusable and will
require factory re-initialisation
CDR-882 Service Manual Version 1.3 Page 36 of 37