Power Supply Removal; Figure 2.5-1: Remove The Four Screws And Disconnect The Molex Type Connector; Figure 2.5-2: Cdr-882 Switched Mode Power Supply - HHB CDR-882 DualBurn Service Manual

2.5 Power supply removal

To remove the switched mode power supply from the chassis:
1. Disconnect the "Molex-type" connector ("B" in Figure 2.5-1) and remove the four
screws ("A" in Figure 2.5-1).

Figure 2.5-1: Remove the four screws and disconnect the Molex type connector

The switched mode power supply is the Meanwell PT-65C
replaced if faulty.
See "Power supply - Mean Well PT-65C" in datasheet pack
1
CDR-882 Service Manual

Figure 2.5-2: CDR-882 switched mode power supply

Version 1.3
, and it should be
1
Page 18 of 37