Domain Name Service (Dns) - Xerox Phaser 860 Networking Setup Manual

Domain Name Service (DNS)

The printer supports DNS through an embedded DNS stub resolver. The DNS resolver
protocol communicates with one or more DNS servers to request the IP address for a given
host name or the host name for a given IP address.
To use an IP host name for the printer, the system administrator must have already
configured one or more DNS servers and a local DNS domain name space database.
To set up the printer for DNS, supply an IP domain name and up to two DNS name server
IP addresses. There are two ways to set up the printer:
DHCP — See page 16.
I
TCP/IP — See the next topic, DNS Setup Using CentreWare IS.
I
DNS Setup Using CentreWare IS
After setting the printer's IP address, you can set up the printer for DNS using
CentreWare IS.
1. Connect to the printer via CentreWare IS (see page 23).
On the right side of the main CentreWare IS page, click Properties.
2.
In the Protocols group, click TCP/IP.
3.
4. Under DNS Settings set Domain Name Service Resolver to On.
5. Enter the following information:
Primary Name Server IP Address (required)
I
Second Name Server IP Address (optional)
I
IP Domain Name (required)
I
Additional Search Domain Name(s) (optional)
I
6. When you are finished entering the settings, click Save Changes at the bottom of the
page.
Note
New parameters will not take effect until the printer is reset.
Resetting the Printer Using CentreWare IS
1. Connect to the printer via CentreWare IS (see page 23).
2. On the right side of the main CentreWare IS page, click Properties.
3. Under the General tab, select Resets.
4. Click Reset Printer.
The printer will not update the web page until it finishes resetting.
Networking Setup Guide
Setting the Printer's IP Address
17