Mounting The Epsa; Fuses - Toshiba Strata VI Manual

SECTION 100-006-255
EPSA-104 INSTALLATION
DECEMBER 1982
01.20 Mounting the EPSA
01.21 Press the anchor legs of the
togglers together, and insert them in to
the anchoring holes (Figure 3) until
their neck flanges are flush with the
mounting surface. If insertion is diffi-
cult, tap them lightly with a hammer.
Legs
FIGURE 3
Wall Surface
I
01.22 Insert a toggler key into the
small hole in the neck of each fas-
tener, as shown in Figure 4. This
should cause the anchor legs to
11
pop
11
open. Remove the toggler key.
Toggler
T
Surface
FIGURE 4
01.23 Thread the screws into the
small holes in the center of the tog-
glers. Leave approximately 3/16-inch
clearance between the bottom of each
screw head and the mounting surface
(Figure 5).
FIGURE 5
01.24 Place the EPSA against the
mounting surf ace with the screws pro-
truding through the holes (Figure 6).
Sheet Metal
~
Spare Battery
Fuse
~
Spare
DC Fuse
FIGURE 6
01.25 Lower the power supply so
that the narrower portions of the holes
slip
over
the screws and the weight of
the power supply is supported. Tighten
the screws.
01.30 Fuses
01.31 Remove the spare fuses from
the hardware carton, and place them in
their individually marked holders (see
Figure 6).
- 2 -