01 General - Toshiba Strata VI Manual

01 GENERAL
01.01 The EPSA-104 is equipped
with a built-in wall mounting bracket,
as shown in Figure 1, to allow it to be
mounted on a wall or other flat,
vertical surface.
~
•
~Terminal
. • Strip
FIGURE l
Spare
Fuses
01.02 Unpack and inspect the EPSA-
104 and the enclosed hardware. Exam-
ine the package and make careful note
of any visible damage. If any damage
is found, bring it to the attention of
the delivery carrier and make the
proper claims.
01.03 Check the hardware list; if it
is determined that any equipment within
the carton is missing, contact your
Toshiba supplier immediately.
01.04 The following hardware, which
is required to mount and connect the
EPSA to the system, is supplied with
each unit.
ENCLOSED HARDWARE
Quantity Item
2 T.C. Toggler Wall Fasteners
(Figure 2)
- l -
SECTION 100-006-255
EPSA-104 INSTALLATION
DECEMBER 1982
2 #14 Hex Head Sheet Metal
Screws
1 Toggler Key
1 Template
P/N 117260-001 (to space the
wall fasteners properly).
1 AC Fuse (spare)
P/N 116438-088 (Fl, 5 amp,
SLO-BLO 125 VAC)
1 DC Fuse (spare)
P/N 116438-030 (F2, 10 amp,
Fast-BLO, 32 VDC)
1 16 AWG, 3-wire Jacketed
Cable (54 inches)
Toggler
Flange
l
'
Toggler
Neck
FIGURE 2
01.10 Surface Preparation
01.11 Choose a suitable location on
a vertical surface for the EPSA, and
attach the template to that location
temporarily. Use a spirit level to
verify that the drilling points are level.
01.12 Place punch marks on the
mounting surface through the two
"+"
marks on the template.
01.13 Enlarge the two punch marks
with an 1/8-inch drill bit.
01.14 Drill through the mounting
surface with a 5/16-in. bit to prepare
the anchoring holes.