Air Filter Replacement; 1Preparation; 2Reactivation Air Filter - Munters MCD100G User Manual

6.10 Air filter replacement
6.10.1 Preparation
1. Set the mode switch to position 0.
2. Wait 60 seconds for the heater to cool down.
3. Set the main power switch to position 0 and lock the switch.
6.10.2 Reactivation air filter
1. Open the two latches and lift off the end panel from the filter box, see Figure 6.1 and Figure 6.2 .
2. Pull out the filter from the filter box, see Figure 6.3 .
3. Clean the filter box using a vacuum cleaner.
4. Push the new filter fully into the filter box. Make sure that the arrow on the filter points in the same
direction as the air stream, see Figure 6.4 .
5. Install the end panel and close the latches.
Figure 6.1
Figure 6.3
190TEN–1081–J1408
Figure 6.2
Figure 6.4
Service and maintenance 49