CCM Roadster 2024 Owner's Manual page 29

3
Once most of the oil is drained remove the oil strainer (3) by unscrewing the 2
fastening bolts and inspect for debris, clean and replace.
Remove the oil filter cover (4) and oil filter element.
Fit a new prefilled oil filter element and replace the filter cover.
Replace the oil strainer, oil strainer drain plug and oil sump plug using new
sealing washers (tighten to the correct torque found in the Torque section of
this manual)
Fill the engine with the specified amount of engine oil.
4
Run the engine until the fan kicks in then for a further one minute to ensure it is
at the correct operating temperature.
Check the oil level in the inspection window and adjust if necessary.
Always check for signs of leaks after performing an oil change and do not ride
the motorcycle if anything is seen.
 Braking system
Checking operation of brakes
Operate both brake levers, the pressure points must be clearly perceptible.
If pressure point is not clearly perceptible, bleed the brake system and re-check.
If problem persists, check system for damage and contact approved service
provider.
Checking brake pad thickness
Brake pads worn past the minimum permissible thickness can cause a reduction
in braking efficiency and under certain circumstances they can cause damage
to the brake system.
In order to ensure the dependability of the brake system, do not permit the brake
pads to wear past the minimum permissible thickness.
Visually inspect the condition and thickness of the brake pad friction material.
NOTE
To change the front brake pads on a Bobber or RAF with 16inch wheels, remove 5
of the 6 front disk bolts and rotate the disk forwards to give clearance for the
calliper to be removed.
1
26