Table of Contents
Advertisement
Maintenance
Running In
To ensure the best performance and reliability of your motorcycle, it is important that the following running in procedure is followed. Failure to comply may result in warranty
invalidation.
At all times;
• Do not use high engine speed when engine is cold.
• Avoid labouring the engine. Downshift before engine "struggles".
• Do not use higher engine speed than required. Using a lower gear increases fuel economy and reduces environmental and noise pollution.
<500 Miles
Do not use full throttle.
Vary the throttle opening and engine-speed range frequently.
Avoid maintaining constant engine speeds for prolonged periods of time.
Avoid exceeding 6000 RPM engine speeds.
Do not exceed 75mph.
Avoid aggressive acceleration and deceleration manoeuvres, except in an emergency.
500 – 1000 Miles
Ensure first service (as per Service Record) is carried out.
Maximum engine speed can be gradually increased to the rev limit for short periods.
Daily Checks
See "Pre-Ride Checks" section.
24
Advertisement
Table of Contents
