Gps Navigation - Sena SF Sereis User Manual

6.3

GPS Navigation

6.3.1 GPS Pairing
1. Turn on the headset and press the Center Button for 10 seconds
until you hear high-toned double beeps. You will also hear a voice
prompt saying "Configuration menu."
2. Triple tap the (+) Button and you will hear a voice prompt saying
"GPS pairing."
3. Search for Bluetooth devices on the GPS navigation screen.
Select the Sena SF Series in the list of the devices detected on
the GPS.
4. Enter 0000 for the PIN.
5. The GPS confirms that pairing has completed and the SF Series
are ready to use. You will hear a voice prompt saying "Your
headset is paired."
6. If the pairing process is not completed within three minutes, the
SF Series will return to stand-by mode.
Note:
When Audio Multitasking is enabled, if you pair your GPS device via GPS
Pairing, its instructions will not interrupt your intercom conversations, but
will overlay with them.
6.3.2 GPS Pairing as Mobile Phone
If a GPS is not only used for turn-by-turn voice instructions but also is
your preferred Bluetooth stereo music source, you can pair the GPS to
the SF Series by following the simple procedures in 5.1, "Phone
Pairing." However, since some GPS systems support mobile phone
bridging over Bluetooth, you can pair the mobile phone to the GPS to
use your mobile phone. When you do this, the SF Series think the GPS
is a mobile phone so you can no longer pair your mobile phone to the
SF Series directly. Please refer to the user's guide of your GPS for
details.
SF Series
19