Disconnecting The Copystation (With A Disk Drive) - Tektronix Phaser 540 User Manual

6
Moving and Shipping

Disconnecting the CopyStation (with a disk drive)

6-2
Phaser CopyStation
1. Switch the CopyStation's, printer's and disk drive's power off.
2.
Remove the SCSI cable connecting the CopyStation to the disk
drive.
a. On both ends of the cable, pull the wire clips away from the
cable's plugs to unfasten them from the connectors.
b. Pull the cable's plugs away from the connectors.
3. If you are not moving the printer and the disk drive:
a. Terminate your disk drive's open SCSI port. Refer to the disk
drive instructions if you are not familiar with this procedure.
b. Switch the disk drive's power back on.
c. Wait 20 seconds, then switch the printer's power back on.
4. Proceed to the next topic in this chapter: "Putting the copier
mechanism in the parked position."