Placing The Copystation - Tektronix Phaser 540 User Manual

2
Setting Up

Placing the CopyStation

2-4
Phaser CopyStation
1. Place the CopyStation near the printer, allowing adequate
ventilation and clearance:
a. Provide a minimum of 8 cm (3 inches) of space at the
CopyStation's left and right sides and at the front and rear.
This will allow for proper ventilation and adequate cabling
access. (Leave an extra 6 inches at the back of the CopyStation
for cable-connection and address-setting procedures.)
b. Allow at least 42 cm (17 inches) of clearance space above the
CopyStation's document cover. This will allow it to remain in
its raised position without assistance.
2.
Slide the Phaser™ CopyStation Quick Reference card under the
CopyStation (it is designed to rest between the CopyStation's feet).
3. If you will be connecting a disk drive to the printer, allow
adequate room for it also. Refer to the disk drive manufacturer's
instructions for placement and clearance recommendations.
9020-12