Table of Contents
Advertisement
Problem
The printer ejects
blank pages.
Half of the page is
blank.
The printer prints the
wrong data, or it
prints incorrect
characters.
34 • Chapter 3
Possible Cause
The image cartridge is not
installed properly.
The image cartridge is empty.
The page layout is too complex.
The page orientation setting may
be incorrect.
The paper size and the software
paper size settings do not match.
Scaling may be set to less than
100%.
The interface cable specifications
may be incorrect.
The interface cable might not be
connected properly.
There may be a problem with the
printer driver software.
The interface cable specifications
may be incorrect.
Remedy
Remove and reinsert the image
cartridge.
Replace the image cartridge
(refer to "Replacing the Image
Cartridge" on page 41).
Simplify the page layout and
remove any unnecessary
graphics from the document if
possible.
Install more memory (refer to
"Installing a SIMM" on page 46).
Change the page orientation in
the Printer Setup dialog box.
Insert the correct paper into the
printer or change the software
paper size settings.
Change the Scaling setting in the
Printer Setup dialog box.
Use the interface cable supplied
with the printer or replace the
cable with an IEEE-1284 rated
cable.
Check the interface cable
connection.
Exit Windows and reboot the
computer. Turn the printer off and
then back on again.
Use the interface cable supplied
with the printer or replace the
cable with an IEEE-1284 rated
cable.
Advertisement
Table of Contents
