Snmp - Xerox DocuColor 6060 Getting Started

DOCUSP 3.74

SNMP

4-10
The list of supported MIBs documented in the Document
Services Platform Series Common Controller System
Guide are incorrect. The section on SNMP MIB support
on page 2-5 should read as follows:
The information displayed in an SNMP Manager may not
always reflect the exact status of a printer on the
DocuSP controller. The SNMP Managers that do not
support loading Management Information Bases (MIBs)
only display the printer status that the Manager supports.
DocuSP 3.x SNMP MIB file uses the Xerox Common
Management Interface (XCMI) version 4.0. The
following lists the MIB files included for version 4.0:
¨ rfc1213 - RFC1213-MIB (MIB-II) - specifically
system, ifNumbers, at, ip, tcp, icmp, udp, snmp
¨ rfc2790/rfc1514 - HOST-RESOURCES-MIB (XCMI
rev 000817) - rfc2790 is a later version of rfc1514.
Specifically hrDeviceTable and hrPrinterTable:
hrSystem, hrStorage, hrDeviceTable,
hrPrinterTable, hrDiskStorageTable,
hrPartitionTable
¨ rfc2790t - HOST-RESOURCES-TYPES (XCMI rev
000815) - same as 2
¨ rfc1759 - Printer-MIB (XCMI rev 000818) - except
finTables
¨ 06gentc - XEROX-GENERAL-TC
¨ 07gen - XEROX-GENERAL-MIB
¨ 10hosttc - XEROX-HOST-RESOURCES-EXT-TC -
same as 2
¨ 11hostx - XEROX-HOST-RESOURCES-EXT-MIB -
same as 2
¨ 15prtxtc - XEROX-PRINTER-EXT-TC
¨ 16prtx - XEROX-PRINTER-EXT-MIB
¨ rfc1215 - SNMP Traps version 1
XEROX DOCUMENT SERVICES PLATFORM SERIES
GETTING STARTED