Scanner Job Templates - Xerox 8830 Operator's Manual

Scanner Job Templates

The "Job Template" option is used to simplify the finisher use.
All of the finisher settings can be stored in nine different Job
Templates. (refer to the "XES Synergix 8825/8830/8850/8855 Digital
Solution User Guide" for details).
By recalling a template number, all of the selections that are stored
(Folding method, Cross, Punch, Title Block Location...) are
automatically set.
A good way to create the templates is to refer to the standard Title
Block Location numbering as shown in the picture below.
4
Upper
Rigth
3
Lower
Rigth
1. Set all of the options and Title Block Location to Upper Right.
2. Save the Job Template as "4"
3. Change only the Title Block Location to Upper Left and save
another Job Template as "1".
4. Create the templates "2" and "3" in the same way.
September 2001
1
Upper
Left
2
Lower
Left
With these four templates it is easy to manage different sizes that have
to be folded with the same folding method.
Depending on the size orientation, the only thing to do is to recall the
template with the proper Title Block Location. All of the sizes fed in
different ways will result folded with the same Face Orientation.
Job template
4
Job template
3
Using the other templates, it is possible to save another finisher setting
with the four title block combinations.
The procedure works only with standard sizes.
For non standard sizes the only possible locations are:
Location 4 Upper Right - Face Up
Location 2 Lower Left - Face Down
88XX Series Folder Operator Manual 31
Job template
1
Job template
2