Table of Contents
Advertisement
Beginning the Measurement
1. Press the New Msrmnt key.
2. Press
Yes, Proceed
The HP 3048A now addresses each
of the instruments listed in its System Configuration
table. If it does not receive a response at the address
listed for an instrument, it will inform you with a
displayed warning. (Refer to Appendix A if you need
information about adding or changing an instrument in
the HP 3048A's System Configuration table.)
Note
Although not shown in the Connect Diagram, the rear-panel
cable connection described in Appendix A (SOURCE OUT
to NOISE INPUT) is required. Also, the 50ft load must be
connected to the SPECTRUM ANALYZER OUTPUT
whenever an RF spectrum analyzer is not being used.
3-32
Signal Source Applications
Advertisement
Table of Contents
