Worksheet
HP 3561A OYNAMIC
SIGNAL ANALYZER
Diagram
1. Draw lines to show cable connections.
2. If you wish to have the HP 3048A control your device-under-test, list the required
command codes below for addressing your DUT and for setting its frequency and
amplitude.
DUT Setup String:
VCO Source
1. Enter the tuning characteristics for the VCO you are using in the spaces below. (Table
3-15 provides the tuning characteristics for several VCO source options.)
Tuning Constant (sensitivity)
Hz/V
Center Voltage of Tuning Range
V
Tuning Voltage Range
±
V
Input Resistance of Tuning Port
Ohms
Reference Source
1. Obtain a plot of phase noise and spur characteristics if available.
Signal Source Applications
3-91