Table of Contents
Advertisement
AM Noise Using
anHP11729C
This example demonstrates the AM noise measurement of
an HP 8662A Signal Generator using the AM detector in the
HP 11729C Carrier Noise Test Set.
Required Equipment
The following equipment is required for this example in
addition to the standard HP 3048A system and your
device-under-test (DUT).
Note
To ensure accurate measurements, you should allow the
DUT and measurement equipment to warm up at least thirty
minutes before making the noise measurement.
Table 3-19. Additional Equipment Required to
Perform this Measurement Example
■ E q u l p r n ^ n t H
^ ^ ^ ^ ^ H
C#>UD^§©
/^aMBSfta?
©em ©sfflm
®ft II
©annnaas
I
1
1
2
2
Must be entered in System
Configuration Table (refer to
Setting up the HP-IB Addresses in
Appendix A for procedure.
Option 130
Two 10 dB attenuators or one 20 dB
attenuator to prevent overdriving the
input to the HP 11848A.
2-foot BNC coaxial cables and
adequate adapters to connect to the
DUT.
3-104
Signal Source Applications
Advertisement
Table of Contents
